Nbr Rubber Sheet,Protective Sealing Strip,Foam Sealing Strip,Rubber Foam Sealing Strip HEBEI JIEXING RUBBER SEALS CO.,LTD , https://www.jiexingrubber.com
Universal milling heads are now widely used in various fields such as aviation, automobiles, and molds. Mainly used in machining centers and portal milling machines, where light can be installed in the magazine and can be freely switched between the magazine and machine tool spindle. Medium and heavy duty have large rigidity and torque and can be applied to most of the processing requirements.
Universal milling head Note 1, the general use of non-contact milling heads oil seal, if the use of cooling water in the processing process, need to run before the water, and adjust the direction of the cooling water nozzle, so that water spray toward the tool, It can avoid the infiltration of cooling water into the body to prolong life.
2, to avoid prolonged processing at the highest speed operation.
3. Refer to the parameter characteristics of each type of milling head and use it under proper processing conditions.
4, before use, need to confirm the test run a few minutes heat engine. Each time you process, you must choose the appropriate speed and feed processing. The speed, feed, and depth of cut during machining should be adjusted progressively until maximum machining efficiency is achieved.
5, general standard milling head processing, need to avoid processing will produce dust, particles of material (such as: graphite, carbon, magnesium and other composite materials, etc.)
What should you watch out for when using universal milling heads?>
With the use of milling heads, the machining range and adaptability can be increased without changing the structure of the machine tool, so that some processes that are difficult to complete with traditional methods can be realized, and the workpieces can be repeatedly clamped and the machining accuracy and efficiency can be improved. Because the milling head expands the performance of the machine tool, it is equivalent to adding an axis to the machine tool, and even more practical than the fourth axis in the case that some large-sized workpieces are not easily turned over or the high precision is required.