Working principle of precision filter Stainless steel mechanical filter,Activated carbon filter,Pre-filter tank for water treatment Yangzhou Mustang Air Compressor Co. , Ltd , https://www.aircompressor-ym.com
The onset of the rainy season, frequent rainstorms in the south, and even the rain-reducing north, have continued to rain this year. For many car owners, the biggest concern is to face stormy weather or multiple water sections. What if the engine accidentally enters water? How to repair it? Here, Xiaobian gives you some tips.
Once the vehicle water is turned off, you must not try to re-ignite, because in the heavy rain or wading state, can not determine what is causing the flameout, so the surest way is not to start the idea of ​​starting the engine. General engine water intake usually has the following three conditions:
In the first case: After the vehicle has been soaked in water, it has been dragged back to the repair shop and the engine has not been started; this situation is that the vehicle was only passed through the water once and was subsequently towed to the repair shop. It was not started halfway. The engine will basically not cause irreversible damage to the engine. The main task is to clean the internal water of the engine, but depending on the situation, consider the degree of cleanliness. In more cases, remove the intake pipe and the intake manifold. Use compressed space to dry the water inside.
In the second case, the vehicle is driving in the water, and the engine is turned off due to flooding; if your car is annihilated in the water, the maintenance engineer will most likely ask you to authorize them to dismantle the engine.
First, it is necessary to judge whether the connecting rod is deformed during this abnormal flameout. By measuring the caliper, it is possible to compare the distance between the two pistons at the same position to the upper edge of the cylinder. If there is a difference between the two values, the larger value may be the deformation of the connecting rod. Of course, it may be two. There is a problem with this. It is necessary to confirm that the edge of the piston is flush with the rain cylinder by rotating the crankshaft to bring the two pistons to the top dead center position. After one by one investigation, it is entirely possible to determine which cylinder has a problem in order to order related accessories. However, for maintenance engineers, they always advocate replacing all connecting rods and pistons in order to achieve better maintenance results.
The third situation: After a small amount of water enters the engine, the owner starts the engine without knowing it and runs for a certain distance. How to determine the damage of the engine? If you cannot turn the crankshaft with a wrench, you can initially determine that the connecting rod is severely damaged. After dismantling, the engine cylinder, connecting rod, and piston must be replaced as a whole. The specific detection situation is the same as the second case.
It is suggested that in the face of the situation of the engine's water intake, it is necessary to calmly handle it. I hope that everyone can minimize travel in bad weather and try to avoid this situation.
Precision filter is mainly composed of filter container, support basket and filter bag these three parts. It's made of stainless steel. Flange precision filter is divided into 1,2,3 and 4 filter bags according to the size of the filter bag. Liquid inlet and outlet direction is divided into side in bottom out type and bottom in bottom out type.
When the precision filter is working, the liquid enters the filter bag supported by the supporting mesh frame from the interface. The filter bag will be evenly expanded to the periphery by the impact of the liquid, so that the liquid can be evenly distributed on the inner surface of the whole filter bag. The liquid passes through the filter bag and is discharged from the outlet at the bottom of the filter. The filter residue is left to be intercepted in the filter bag.
When the filter bag can be replaced after running for a long time, or when the pressure difference between the inlet and outlet reaches 0.05-0.07mpa during use, the filter bag also needs to be replaced.
How to do engine water
Next Article
Car Three Guarantees Policy