Textile Sublimation Printing Machine Textile Sublimation Printing Machine,Custom Printing,Transfer Paper Printing,Polyester Sublimation Printing Shenzhen Textalk Graphic Technology Co.,Ltd , https://www.textalkdigital.com
1, turn on the power
After pressing the key, the LCD will display for about 3 seconds, then the model number, type name, “TIMES†(measurement times) and “%†will be displayed. When the instrument generates an abnormal situation, an error message will be displayed. Please refer to “10 "Error display" section.
2. Variety selection
Press the selection key and the number will increase by one digit for each press. It is 1 after 12 of the item number. The model number will also be automatically stored after the power is cut off. When the power is turned on again, the model number before power off will be displayed.
3. Put the sample into the sample cup
Place the hopper on the sample cup and load it into the sample. When it is full, move the hopper horizontally. The excess sample is scraped off horizontally by the hopper so that the amount of sample reaches exactly one cup.
4. Pour the sample into the measuring section of the instrument
Press the measurement key and the decimal point will flash. Since the electronic balance is adjusting the zero point during this time, please do not touch or shake the instrument.
After the "POUR" interval flashes, the sample is poured into the sample, and the center of the aiming measurement unit is immediately put into the measurement unit within 5 to 6 seconds. If the process stops halfway, the electronic balance will consider the input to be completed and measure it immediately. If you re-inject the sample, the instrument cannot make the correct measurement.
The sample surface should be leveled when feeding
"POUR" disappears, and after the decimal point is flashed four times, the moisture value and the number of measurements are displayed.
When “POUR†disappears and the decimal point is flashing, the instrument is measuring. Therefore, even if the sample leaks, do not input any more. Otherwise, the correct measurement cannot be performed.
* When the moisture value exceeds the measurement range, "FFF" is displayed when the value is higher than the measurement range. "AAA" is displayed when the measurement range is lower.
5. Drop the sample
At this time, the display of the moisture value remains unchanged, and when the measurement is continued, the sample is started from “3†after the sample is loaded into the sample cup.
The above is the measurement method of PM-8188 grain moisture meter. When using, please strictly follow the above operation steps in order to obtain the correct moisture content value.
Determination method of PM-8188 grain moisture meter
PM8188 Japan Kate computer moisture meter is an imported grain moisture meter. Because it is small and portable, it is also called a handheld moisture analyzer. PM8188 Japan Kate computer moisture meter can determine wheat, corn, soybean, barley, mung bean, millet, sorghum, rapeseed, red adzuki bean, peanut, milled rice, rice, these 12 varieties can quickly obtain the moisture value of these cereals , Not only high precision, but also easy to use, the following will introduce the measurement method of PM-8188 grain moisture meter.
Next Article
JIS Standard 5k Steel Flange