Candle Filter,Steel Filter Candle,Candle Filter Water Purifier,Steel Water Filter Candle ANPING HANKE FILTER TECHNOLOGY CO , https://www.anpinghankefilter.com
Multifunctional aerial pliers using methods and precautions
Instructions:
1. Install the wiring pliers on the dedicated operating rod of the required length, install the wires of voltage and current on the terminals of the jaws of the wiring pliers, and then segment the wires (a section near the wiring pliers
Must reserve a 20cm margin), fixed on a dedicated operating lever.
2. Make the pliers of the wiring pliers at a high speed approximately the same angle as the wiring position (if the wiring position is perpendicular to the ground, replace the standby guide hook).
3. Lift the wiring clamp with a special operating lever so that the clamp head is slightly higher than the wiring position and gently lean against the wiring position. Rely on the guide mechanism on the wiring clamp to slowly slide downwards at the wiring position. Position, and then slowly use force (do not use too much force) to pull the special operating lever, clamping jaws.
4. When removing the wiring pliers, just push the dedicated operating lever to the direction of the wiring pliers and the jaws can be opened.
Use cautions:
1, must read the user manual before use.
2. When using, you must pay attention to maintaining a safe distance from the charged device!
When using the wiring pliers, all the wires are connected. When lifting or lowering, keep a safe distance from the surrounding devices. Special attention must be paid to safety!
3, if the jaws are clamped on the screw, the clamping force is small or the connection line is bad, it will affect the test results.
4. When taking it down after use, be sure to handle it with care.
5. Never push the lower jaw of the wiring pliers upwards, bend or squeeze the steel wire rope inside.
6. Pay attention to the lubrication of sliding parts and avoid dust.
7. It should be kept in a clean and dry place after use.
Multifunctional aerial pliers
#FormatImgID_0#