Polyproplylene Rope available in: 3-strand, 6-strand, 8-strand,12-strand, 24-strand, Polypropylene Rope Polypropylene Rope,8 Strand Polypropylene Rope,PP Polypropylene Rope,3 Strand Polypropylene Rope Jiangsu Xiangchuan Rope Technology Co., Ltd. , http://www.xcropes.com
Everyone should have a question. I bought your combustible gas detector. How do I judge it to work? In fact, this method is very simple, the general workshop will save the experimental gas, we only need to part of the gas or liquid in a mineral water bottle, screw on the lid, insert a small hole in the lid with a sharp thing, the small mouth in the flammable gas At the detector's probe location, you can see if the reading on the gas detector panel changes.
Special attention is paid to the fact that some combustible gases are in a liquid state and they evaporate relatively slowly. Therefore, in tests, it is necessary to shake the water bottle to accelerate its evaporation. Another point: The stationary gas detector is generally a natural diffusion. Only when the leaked gas diffuses into the alarm equipment will the device react.
If you feel that this method is too much trouble, if the ZR-UHZ magnetic flap level gauge of our company allows, you can use the lighter experimental gas detector to read. Method: Use a lighter to blow out the fire, but do not let your hand open, so that the lighter is still deflated, aiming at the gas detector probe, but not too long, because the lighter fuel gas concentration is high, If the time is too long, the concentration of gas will be too high and exceed the range of the gas detector. In the long term, the life of the gas detector may be shortened.
If you want to know if the gas detector is accurate, it's a bit difficult. At this time we must know the exact concentration of gas we use to see if the detector reading is consistent with the concentration value we know (national regulatory standards, allow some errors), if the same or a small difference, indicating that the gas detector can read correctly .
If you can't read the on-site gas detector, please don't worry. The ZR-UHZ magnetic flip plate liquid level meter of our company must first check whether the gas detector is supplying power normally. The voltage is unstable, and the range is too high, but it may also be too large. Causes inaccurate readings. General gas detector detector power supply in the range of 10-30V, more than this range, may result in inaccurate readings.
Polypropylene Rope have unique properties. If you are looking for a light weight rope that floats, this is the rope for you. A very economical rope.
â— Rot proof
â— Will not shrink
â— Resistant to water
â— Resistant to oil
â— Resistant to gasoline
â— Resistant to most chemicals
How to use combustible gas detector correctly
According to the requirements of the state, the gas detector necessary for safe production is an important alarm device that can effectively avoid explosion poisoning accidents caused by gas leakage. Since it is so important, how can we buy it? The company's product ZR-UHZ magnetic flap level gauge how to determine whether this combustible gas detector equipment can work properly, is it available? Below to give you a simple analysis, the purchase of similar equipment to determine the method!