Features for Feed Off The Arm Sewing Machine: Double lap-seaming, three or two needles, lap-seamers that climb sixteen plies with ease; Upper puller and differential feed Chainstitch with high step, the denim feeding is easier&smoother; This series machine supply various function, annex and Parts, convenient for selecting the most suitable way to finish the seaming; Lower quiver& noise when high speed running. Suitable for stitching on the loop of jeans&leisure trousers, which material from medium to heavy,loop width 8-12mm. Feed Off The Arm sewing machine Feed Off The Arm Sewing Machine,Industrial Feed Off The Arm Sewing Machine,Small Feed Off The Arm Sewing Machine,Double Needle Feed Off The Arm Sewing Machine DONGGUAN CHUANGHUI SEWING MACHINE CO.,LTD , http://www.ch-sewing.com
Monitoring module:
Simulate the alarm signal (or short the module input terminal) on the monitored equipment device. The module confirms that the lamp should be always on or check the alarm condition on the controller.
Where false alarms and failures occur in the monitoring module, first check that the wiring and address codes are correct and correct. Then use a good module installed in this location to determine if it is a module failure. If the module is misreported or faulty, check for moisture and other damage. After eliminating external causes, the BGY-368 should be used to clean the integrated circuit and address code. If it still cannot be used normally, it must be replaced.
Input and output modules:
On the controller or according to the programming simulation control module action signal, the input/output module confirms that the light should be always on, and there is a 24V DVC output on the module terminal.
Where false alarms and faults occur in the input and output modules, first check that the wiring and address codes are correct and correct. Then use a good module installed in this location to determine if it is a module failure. If the module is misreported and faulty, check if it is damp, and if there is any other damage. After eliminating external causes, the BGY-368 should be used to clean the integrated circuit and address code. If it still cannot be used normally, it must be replaced.
How often should the fire protection maintenance be known to you?
The fire control module is an important part of the fire-fighting linkage control system and is an indispensable left arm and right hand brake in the automatic fire alarm system. Fire module maintenance rules.