Coke pressure ball drying process equipment configuration?

Coke pressure ball, Drying Process is as follows:

1. Forming of coke forming The first stage: equipped with a quantitative feeding system. This means that the entire production line is “collapsed” due to the uneven production of the production line during the production process. As a result, the entire production line equipment is not matched. As a result, the equipment is not directly proportional to the incoming and outgoing products. What often goes wrong is the normal production and benefits of the customer. Therefore, equipment matching is a key issue.

2. Crushing stage in the second stage of forming of coke: The particle size of the coke forming material is generally 0-3mm, so that the material plays a decisive factor in forming. If the material is more than 5mm, the forming difficulty will increase, and the molding rate will be affected. The forming difficulty will be also less than 1mm and the molding rate will also be affected. Therefore, the general pressure ball size 0-3mm. In contrast, the hardness of coke is not so great, and it is very difficult to crush it. So you can use ordinary grinders.

3, the formation of coke forming the third phase of the material added to the binder, are mixed with: the mixer is divided into the following categories: vertical mixer, horizontal mixer and wheel roller mixer. The selection of the mixer can be determined according to the material conditions of the mixer (for example, the dry humidity of the water, the degree of cleanness of the material, etc.). The following is a brief description of adhesives. There are many types of adhesives. Divided into two major sections: organic and inorganic. Organic and inorganic are wet adhesives and dry adhesives (dry powder series). As the name implies, inorganic binders are nitrogen, lin, and potassium single element binders; organic binders are composite binders, and adhesives produced by chemical units are finished adhesives. There are cold strength, thermal strength, can be more according to the difficulty of molding materials or materials do not allow the addition of other elements and other related issues can be solved one by one.

4, through the above equipment program, the next step is the material pressure ball forming stage, my unit processing pressure ball forming equipment more than 20 years of pressure ball forming equipment is also divided into a variety of. They are mechanical type, constant pressure oblique iron type, butterfly spring type, hydraulic pressure type, high pressure type, spiral pressure high pressure type and so on.

Forming physical moisture is 8% -12%, water exceeding this value will cause the material to stick to the mold affect the molding rate and increase the difficulty of manual processing; moisture below this value will lead to the material molding density can not be achieved, adhesion The agent does not achieve adhesion, low molding rate and other related problems.

5. After the material is formed, the formed pellets are then dried. There are many drying methods for my unit, vertical dryer (round, square), mesh belt dryer, chain plate dryer, box dryer and so on. Select drying equipment according to the size of the molding pellets. Different drying equipment, drying methods are also different.

6, then other coke-related equipment will not give you one by one to explain, the specific configuration or based on their needs, mode of operation and site area, water and electricity and other related issues to choose matching oh. In addition, the connection of each device is connected with the conveyors one by one. Only in this way can an intelligent and automated management system be used. Reprovisioning distribution cabinet automatic integration operation.