The water flow rate of the sprinkler depends mainly on the flow of the sprinkler pump loaded on the vehicle, as well as the number of sprinkler heads, and the throttle of the sprinkler engine. The following small series briefly introduces the basic structure of the following sprinklers. The sprinkler is mainly composed of a chassis, a tank body, a tank opening, a power take-off, a water pump, a ball valve, a water sprayer, and a pipe. The tank body is usually elliptical or square, made of steel plate, the tank body of the tank is 2-3 chambers, the bottom of the middle partition has a through hole, and the inner partition of the tank has an anti-wave structure to reduce the inside of the tank when the vehicle is running. The impact of the liquid. The power take-off needs to be operated pneumatically or manually. The operation switch is pulled backwards, the power take-off enters the meshing position, and the hand pump is driven by the drive shaft. When the switch returns to the position, the pump stops working. The power take-off of each sprinkler is a dedicated power take-off that matches it. Each sprinkler is equipped with a sprinkler pump on the bottom of the tank. The vehicle engine drives the power take-off. The power take-off drives the drive shaft. The drive shaft drives the sprinkler to work, so that the water in the pipeline is sprayed out. The flow rate of the sprinkler directly affects the water flow of the sprinkler. The pump flow can be seen from the model of the sprinkler. As for which type of sprinkler pump to use, it depends on the volume of the sprinkler tank. 5 ton and below sprinklers are generally equipped with: 65QZ40/50 self-priming sprinkler pump with a flow rate of 40 cubic meters per hour, ie: 666 liters / minute, equivalent to 11.1 liters / sec; its lift is 50 meters; The 8 ton and above sprinklers are generally equipped with: 80QZ60/90 self-priming sprinkler pump with a flow rate of 60 cubic meters per hour, ie: 1000 liters / minute, equivalent to 16.6 liters / sec, with a lift of 90 meters; Some sprinkler customers also choose: 65QZ50/110 self-priming sprinkler pump, the flow rate is 50 cubic meters / hour, that is 833 liters / minute, equivalent to 13.8 liters / sec, the lift is 110 meters. When you see this, you may ask: Is there a problem with this flow? The 5 ton sprinkler can only calculate a can of water for 7 or 8 minutes?! Actually, because the pump inlet and outlet diameter is 65mm or 80mm (2.5 inch or 3 inch), the sprinkler nozzle can't be so big, so the pump's water flow does not mean the sprinkler's water flow unless you are connected externally. Fire hose or water pipe for pumping or spraying water. Therefore, under normal circumstances, a 5 ton sprinkler can be sprinkled for 20-30 minutes at a time. The working speed of the municipal sanitation sprinkler is about 15-20km/h, and the speed can reach 40km/h, so that a 5 ton sprinkler is counted. A tank of water can only be sprayed for a distance of up to 20km. The sprinklers come standard with 4 sprinkler heads: three-bend front punch, rear sprinkler, duckbill side spray, high-pressure water cannon, each with a separate pipe ball valve to control the opening and closing of the nozzle. The more sprinklers are opened, the greater the water flow, the more the water pressure is dispersed, and the road flushing effect is reduced accordingly. This is why some sanitation sprinklers use only one front punch for road sprinkling. But this is a good thing for green sprinklers. Plant watering does not require much pressure. Installing a sprinkler can alleviate the problem of excessive water flow impact, and it can increase the amount of watering. Therefore, the high-level shower position of the green sprinkler is generally 2 nozzles, and often customers will require 3-4 nozzles. This is the reason. In addition, the greater the pressure of the water in the sprinkler pipe, the greater the water flow will naturally increase. The way to increase the water pressure of the sprinkler is to increase the throttle, but for the sanitation road sprinklers in the driving process, the working speed is generally limited. The water flow and tonnage of each sprinkler are different. The user chooses mainly according to the size of the pump. Therefore, the choice of the pump also requires extra care. Fan Bracket,Wall Fan Bracket,Ceiling Fan Mounting Bracket,Ceiling Fan Bracket Ningbo Maixun International Trade Co., Ltd , https://www.maixuncarparts.com
sprinkler 
The basic structure of the sprinkler 
Water pump 
Pump model description 
Sprinkler external port car introduction 
Working sprinkler
Buying a sprinkler, are you still concerned about horsepower? NO, you should pay attention to water flow and tonnage
Sprinklers range from 2 tons to more than 30 tons, but many people don't know how many tonnage sprinklers should be purchased. Let's give you a reference.