3pe anti-corrosion pipe fittings in the installation of a lot of things that need attention, the same, in the assembly and operation are also indispensable to pay attention to a series of problems, because this also affects the use of the effect. The following small series to introduce you to the following points: 3pe anti-corrosion pipe fittings installation precautions 1,3pe anti-corrosion pipe manufacturers in the 3pe anti-corrosion pipe in the process of moving, because the metal compared to the hardness of the tube is relatively small, so the need for special maintenance to prevent mechanical damage, resulting in unnecessary Loss. 2, ppr pipe if the temperature in the five degrees Celsius, the hardness will be lower, is the low temperature brittleness, so in the winter construction should be more cautious. Use a sharp knife when cutting the pipe to cut slowly. The installed pipeline is covered to maintain coverage, to avoid being pressure or impact. 3, after the completion of such pipe assembly in the sealing tube and cover the decoration level must be tested before the pressure. The pressure of the cold water pipe test is one and a half times the pressure specified on the device but not less than one megapascal; the pressure of the hot water pipe is twice the pressure that it is required to achieve, but it can not be less than one point Five megapascals. 4,3pe anticorrosive pipe manufacturers 3pe tube Ming Fu or non-burial dark deposited arrangements placed pipes, be sure to be in accordance with the provisions of the installation of brackets and hangers. 5, ppr pipe if subject to prolonged exposure to UV light will be degraded degradation occurs, so there is no assembly in the wall or the house of PPR pipe must be wrapped in color protection layer. PPR pipe fittings in the assembly and operation, the above mentioned points must not be negligent, because it directly affects our late use and quality problems, I hope we can master and understand the relevant expertise, the better use of 3pe pipe .
At present, the heat metering market commonly used heat table is divided into mechanical heat meter(Mechanical Energy Meter) and ultrasonic heat meter(Ultrasonic Energy Meter).Heat Energy Meter is suitable for measuring
the heat exchange, known as the heat transfer fluid or liquid absorbing thermal
energy conversion equipment, which consists of a flow sensor, temperature
sensor and heat calculator three parts. Heat energy meter (thermal meter), also
known as Heat Meters , heat energy calculator, both measure heating system for
heat and also measure heat absorption cooling system.
Heat energy meter (heat meter) is used to
measure and display the water flow through the heat exchange system release or
absorb heat. Heat energy meter, is also known as energy meters. The heat energy
meters are installed at the inlet pipe or outlet pipe to measure accurate
metering and intelligent control of charges of the heat consumption. Its working
principle is to install Heat Energy Meters in the heat exchange system, when
water flows through the system, according to the supply and return water flow
temperature, from the data from the flow sensors and temperature sensor as well
as the water flow time, the heat energy meter will calculate the released and
absorbed energy through the calculator.
Heat Energy Meters Heat Energy Meter,Heat Pump Energy Meter,Solar Heat Energy Meter,Mechanical Heat Energy Meter,Mechanical Energy Meter,Ultrasonic Energy Meter Berggruen Technology Co.,Ltd , http://www.meter-technology.com
3pe anti-corrosion pipe fittings installation precautions
ã€Print】 ã€Close】